Indicator of Test 2 (only for those participants with glasses that are multifocal or who have progressive lenses), as part of the NIH Toolbox Sensation Domain Vestibular Measure Dynamic Visual Acuity Test

The NIH Toolbox Dynamic Visual Acuity Test (DVA) is a measure of gaze stability during head movement, which helps identify individuals who may have a deficit of the vestibular system (which regulates internal balance). First, the NIH Toolbox Visual Acuity Test must be administered, followed by the DVA Test. Participants are again seated 12.5 feet from a computer monitor at eye level. For the DVA Test, participants wear lightweight headgear that contains a rate sensor and are asked to move the head back and forth, as if saying no. Once the head is measured to be moving at greater than 180 degrees per second by the rate sensor, an optotype flashes on the monitor, and the participant is asked to identify it. As with the Visual Acuity Test, only the letters H, O, T, and V are used for ages 3 to 7 while ages 8+ use the entire letter set. Smaller optotypes are displayed as the participant correctly identifies letters, and larger ones are displayed if the participant cannot correctly identify the letter shown, until the computer has calculated the smallest size that the participant can see with the head moving. This is calculated separately for head rotation leftward and rightward from center (though the participant continues shaking the head both ways), and this performance is compared to the participants visual acuity when the head was stationary (the NIH Toolbox Visual Acuity Test 16 score, sometimes referred to as static visual acuity in the context of the DVA test). The difference between static and dynamic visual acuity represents the vestibular contribution to gaze stability. The DVA Test takes approximately six minutes to administer and is recommended for ages 3-85.

2016-06-03

Copyright 2006-2012 National Institutes of Health and Northwestern University. http://www.nihtoolbox.org/WhatAndWhy/Sensation/Vestibular/Pages/NIH-Toolbox-Dynamic-Visual-Acuity-Test-.aspx

Visual Acuity Test 2 (only for those participants with glasses that are multifocal or who have progressive lenses): Say: Now we are going to do this test again, this time without your glasses. When the participant has removed his/her glasses, the examiner should click the START TEST button on the examiners screen. Each time a letter is displayed, say: Tell me, what letter is this? (At the examiners discretion, this can be replaced by: Go ahead after a few letters have been displayed.) It is the examiners job to use the computer to record whether the response was correct or incorrect by clicking either the Yes (correct) or No (incorrect) button. Simply note the participants response, compare it to the correct answer listed on the examiners screen, and score it accordingly. The next item will not appear until the examiner has scored the item currently on screen (but it will appear immediately after the examiner clicks Yes or No). The test will progressively present smaller letters if the participant answers correctly and larger ones if the participant answers incorrectly, until an acuity score is found. The test will automatically end when the computer has calculated the acuity score.

Tue May 08 11:25:20 EDT 2018

NIH Toolbox Visual Acuity Test

NIH/CIT/BRICS

Malaika Schwartz

mschwartz@sapient.com

NIH/CIT/BRICS

Olga Vovk

olga.vovk@nih.gov